Absolute frequency position of the reference resource block (Common RB 0). Its lowest subcarrier is also known as Point A . Note that the lower edge of the actual carrier is not defined by this field but rather in the scs-SpecificCarrierList.
Read moreWhat is point A in 5G?
Point A is reference point in 5G system . There is another paramater – offset to carrier. By using both parameter UE compute the actual carrier where different BWP reside.13 Mar 2020
Read moreWhat is RRC reconfiguration?
RRC CONNECTION RECONFIGURATION message is the command to modify an RRC connection . The purpose of this procedure is, · To establish/modify/release Radio Bearers. · To perform Handover. · To setup/modify/release Measurements.
Read moreWhat is RRC inactive in 5G?
In 5G, they have introduced new RRC Stats called “RRC Inactive” to minimize latency as well as to reduce signalling load . Transitions from RRC Inactive to Connected is very quick as UE Context is stored at gNB and UE. NG signalling keep alive between gNB to AMF, GTP-U also remain alive between gNB to UPF.
Read moreWhat is reconfiguration with Sync in 5G?
‘reconfiguration With Sync’ IE. Extract the C-RNTI assigned for 5G access . Extract NR information. from LTE RRC Connection.
Read moreWhat is RRC in 5G?
The Radio Resource Control (RRC) protocol is used in UMTS, LTE and 5G on the Air interface. It is a layer 3 (Network Layer) protocol used between UE and Base Station. This protocol is specified by 3GPP in TS 25.331 for UMTS, in TS 36.331 for LTE and in TS 38.331 for 5G New Radio.
Read more